Simulation Transportation Vibration Tester

This equipment test is mainly used to evaluate the strength of the package under the condition of sinusoidal vibration or resonance and the protection ability of the package to the contents. It is also used to test the shockproof and anti-collision performance of the package. The simulated transportation test can also find the structural defects of the product in time in the laboratory, so as to pass the improvement The design ensures that when the product reaches the customer's hand, its performance will not change due to the sea, land and air transportation.

Product features

Humanized operation and control make the equipment work stably and reliably;

It meets the road transportation simulation test and the test requirements of different industries;

Large load capacity, strong anti bias load capacity, amplitude not affected by load, strong anti-interference capacity;

Synchronous excitation, the table vibration is uniform;

Comply with ASTM d999 and ISTA transportation standards;

Easy to operate, unique structure design, no auxiliary work can be operated, simple and safe.

Technical index

Operating speed: 150-300rpm (RPM) adjustable

Time setting range: 1 second ~ 999 hours

Axial vibration: rotary (also known as: horse racing, rotary), the trajectory is oval

Sweep frequency range (Hz): 2 ~ 5

Maximum acceleration (M / S2): 13

Maximum test load (kg): 100

Displacement amplitude (mm P-P): 25.4mm ± 1%

Vibration waveform: sine wave

Excitation mode: Motor Excitation

Speed regulation mode: DC speed regulation

Cooling mode: air cooling

Working temperature requirement (℃): 0 ~ 40

Working humidity requirements (% RH): 0-90, no condensation

Table material: SUS304 stainless steel

Effective worktable size (L × w × h) mm: 1100 × 1000 × 320

Overall dimension (L × w × h) mm: 1100 × 1000 × 700

Safety protection device: over speed protection, prevent motor overload operation, extend the service life of the equipment.

Test description

Place the test sample in the middle of the test bench, move the positioning railings parallel with both hands to the position close to the sample, then fix the test product in a certain range with four baffles, leave a distance of at least 1 inch (25.4mm) between the baffle and the sample, and then tighten the nuts to lock the fence. Adjust the rotation speed according to the weight of the sample to ensure that the sample and the test bench are separated from a certain gap. The light sample has a higher rotation speed, while the heavy sample has a lower rotation speed. During the vibration test, the sample is verified with a metal plate (1.5mm thick, 50mm wide and no less than 800mm long) One end of the bottom surface of the sample slides to the other end. If it can not slide smoothly from the bottom surface of the sample, it is necessary to increase the test speed until it can slide smoothly from the bottom surface of the sample. If the gap between the sample and the table is too large during the test, it is necessary to reduce the test speed. Similarly, the metal plate can slide smoothly from the bottom surface of the sample. Note: the sample should be a complete package.

Applicable standards

ASTM D999 ASTM-D4169-09 ISTA 1A、1B、2A、2B

Equipment parameters

Power supply: AC220 V ± 10% 50 Hz 1P

Overall dimension (L × w × h): (1700 × 1200 × 2715) mm

Net weight: 220kg